Advertisement
debug protocol-tunnel
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
protocol-tunnel
c e s
Syntax
Parameters
Defaults
Command Modes
1338
|
Service Provider Bridging
Enable debugging to ensure incoming packets are received and rewritten to a new MAC address.
debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value]
To disable debugging, use the no debug protocol-tunnel interface {in | out | both} [vlan
vlan-id] [count value] command.
interface
Enter one of the following interfaces and slot/port information:
•
•
•
•
•
in | out | both
Enter the keyword
interfaces, or both incoming and outgoing interfaces.
vlan vlan-id
Enter the keyword
Range: 1 to 4094
count value
Enter the keyword
Range: 1 to 100
Debug Disabled
EXEC Privilege
Version 8.2.1.0
Introduced on the C-Series, E-Series and E-Series ExaScale.
Version 7.4.1.0
Introduced
Enable protocol tunneling per VLAN-Stack VLAN.
protocol-tunnel stp
To disable protocol tunneling, use the no protocol-tunnel stp command.
stp
stp
Enter the keyword
and PVST.
No default values or behavior
CONF-IF-VLAN
For a Fast Ethernet interface, enter the keyword
the slot/port information.
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
For a SONET interface, enter the keyword
information.
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
in
out
both
,
, or
vlan
followed by the VLAN ID.
count
followed by the number of debug outputs.
to enable protocol tunneling on a spanning tree, including STP, MSTP, RSTP,
FastEthernet
GigabitEthernet
port-channel
sonet
followed by the slot/port
TenGigabitEthernet
to debug incoming interfaces, outgoing
followed by
followed by a
Advertisement
