Advertisement
snmp-server view
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Example
Related
Commands
snmp trap link-status
c e s
Syntax
Defaults
Command Modes
Command
History
1370
|
SNMP and Syslog
Configure an SNMPv3 view.
snmp-server view view-name oid-tree {included | excluded}
To remove an SNMPv3 view, use the no snmp-server view view-name oid-tree {included |
excluded} command.
view-name
oid-tree
included
excluded
No default behavior or values
CONFIGURATION
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
E-Series legacy command
The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a sub-tree or
a MIB. The following example configures a view named rview that allows access to all objects under
1.3.6.1:
Figure 54-10. snmp-server view Command Example
FTOS# conf
FTOS#(conf) snmp-server view rview 1.3.6.1 included
show running-config snmp
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
snmp trap link-status
To disable sending link trap messages, enter no snmp trap link-status.
Enabled.
INTERFACE
Version 7.6.1.0
Support added for S-Series
Enter the name of the view (not to exceed 20 characters).
Enter the OID sub tree for the view (not to exceed 20 characters).
(OPTIONAL) Enter the keyword
the view.
(OPTIONAL) Enter the keyword
the view.
Display the SNMP running configuration
included
to include the MIB family in
excluded
to exclude the MIB family in
Advertisement
