Advertisement
Parameters
Defaults
Command Modes
Usage
Information
framing
e
Syntax
Parameters
Defaults
Command Modes
Usage
Information
hardware monitor mac action-on-error port-shutdown
e
Syntax
Defaults
Command Modes
Command
History
1388
|
SONET
c2 value
Enter the keyword
Range: 0x00 to 0xFF hexadecimal (0-255 decimal)
Default: 0xCF in hexidecimal (207 in decimal)
j0 value
Enter the keyword
Range: 0x00 to 0xFF hexadecimal (0-255 decimal)
Default: 0xCC (204 in decimal)
as above
INTERFACE
You enter the flag C2 and J0 values in decimal, but the FTOS displays the values in hexidecimal in the
show controllers sonet command output.
Set the type of framing used on a POS/SDH interface.
framing {sdh | sonet}
To return to the default, enter no framing.
sdh
Enter the keyword
Default: Sonet
sonet
Enter the keyword
Default: Sonet
sonet
INTERFACE
Framing should be changed only when the interfaces are shutdown.
Shut down and bring back up the port (flap).
hardware monitor mac action-on-error port-shutdown
Not configured
CONFIGURATION
Version 7.7.1.0
Introduced command
c2
followed by value to set the path signal byte.
j0
to set the section trace byte.
sdh
to specify Synchronous Digital Hierarchy (SDH) framing.
sonet
to specify SONET framing.
Advertisement
