Advertisement
Usage
When you use this command to redistribute routes into a routing domain, the router becomes an
Information
autonomous system (AS) boundary router. An AS boundary router does not always generate a default
route into a routing domain. The router still requires its own default route before it can generate one.
How a metric value assigned to a default route is advertised depends on how on the configuration of
the
default-information originate
in LSPs will be 63. If the
default-information originate
Related
redistribute
Commands
isis metric
metric-style
show isis database
description
c e s
Enter a description of the IS-IS routing protocol
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description
Defaults
No default behavior or values
Command Modes
ROUTER ISIS
Command
pre-7.7.1.0
History
Related
router isis
Commands
distance
e
Define the administrative distance for learned routes.
Syntax
distance weight [ip-address mask [prefix-list]]
To return to the default values, enter the no distance weight command.
metric-style
command. If the
metric-style
Redistribute routes from one routing domain to another routing domain.
Configure a metric for an interface
Set the metric style for the router.
Display the IS-IS link state database.
Enter a description to identify the IS-IS protocol (80 characters maximum).
metric-style
is set for narrow mode and the metric value in the
command is set to a number higher than 63, the metric value advertised
is set for wide mode, their the metric value in the
command is advertised.
Introduced
Enter ROUTER mode on the switch.
Intermediate System to Intermediate System (IS-IS) | 827
Advertisement
