Advertisement
Related
Commands
queue ingress
e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
1202
|
Quality of Service (QoS)
The no form of the command without multicast-bandwidth and wred-profile, will remove
•
both the wred-profile and multicast-bandwidth configuration.
•
On 10 Gigabit ports only, the multicast bandwidth option will work only if the total unicast
bandwidth is more than the multicast bandwidth.
•
If strict priority is applied along with multicast-bandwidth, the effect of strict priority is on all
ports where unicast and multicast bandwidth are applied.
•
When multicast bandwidth is assigned along with unicast bandwidth, first multicast bandwidth
will be reserved for that port, then the remaining unicast bandwidth configured is adjusted
according to the bandwidth available after reserving for multicast bandwidth.
show queue statistics egress
Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the
Multicast bandwidth queue.
queue ingress multicast {linecard slot number port-set number | all} [wred-profile name]
To return to the default, use the no queue ingress multicast {linecard slot number port-set
number | all} [wred-profile name] command.
linecard number
port-set number
all
wred-profile name
No default behavior or values
CONFIGURATION
Version 7.4.1.0 and 6.5.3.0
This command does not uniquely identify a queue, but rather identifies only a set of queues. The
WRED Curve is applied to all eight ingress Multicast queues.
Note:
The multicast-bandwidth option is not supported on queue ingress. If you attempt to
use the multicast-bandwidth option, the following reject error message is generated:
% Error:Bandwidth-percent is not allowed for ingress
multicast
Display the egress queue statistics
linecard
Enter the keyword
followed by the line card slot number.
E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a
E300.
port-set
Enter the keyword
followed by the line card's port pipe.
Range: 0 or 1
all
Enter the keyword
to apply to all line cards.
(OPTIONAL) Enter the keyword
profile name in character format (16 character maximum). Or use one of the
pre-defined WRED profile names.
Pre-defined Profiles:
wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g
Introduced on E-Series
wred-profile
followed by your WRED
Advertisement
