Advertisement
Parameters
Command Modes
Example
1398
|
SONET
interface
Enter the one of the following interface keywords and slot/port information:
•
For a SONET interface, enter the keyword
information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
EXEC
EXEC Privilege
Figure 55-4. show interfaces sonet with PPP Encapsulation Command Example
(EtherScale)
FTOS>show interfaces sonet 2/0
SONET 2/0 is up, line protocol is up
Hardware is SONET, address is 00:01:e8:00:03:ff
Encapsulation PPP, Framing is SONET, AIS-shut is enabled
Scramble-ATM is enabled, Down-when-looped is enabled
Loopback is disabled, Clock source is internal, Speed is Oc48
CRC is 32-bits, Flag C2 is 0x16, Flag J0 is 0xcc, Flag S1S0 is 0x0
Keepalive Set (10 Sec)
LCP
State: OPENED
IPCP State: OPENED
Internet address is 6.1.5.2/30
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 2488 Mbit
ARP type: ARPA, ARP timeout 04:00:00
Last clearing of "show interfaces" counters 17:08:10
Queueing strategy: fifo
91425052815 packets input, 6188485730919 bytes
Input 91425040617 IP Packets, 0 Vlans 0 MPLS
Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
55176128354 packets output, 3677188351652 bytes, 474 underruns
Output 173858 Multicasts, 0 Broadcasts, 55175954550 Unicasts
55176116090 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 474 discarded
Rate info (interval 299 minutes):
Input 1604.04Mbits/sec,
Output 1169.30Mbits/sec,
Time since last interface status change: 17:10:40
FTOS>
Table 55-3. Fields in the show interfaces sonet with PPP Encapsulation
Field
Sonet 2/0...
Hardware is...
Encapsulation is...
Scramble-ATM is enabled
Loopback is...
Keepalive Set
LCP State:
2583270 packets/sec
1913510 packets/sec
Description
Displays the interface's type, slot/port and physical and line protocol status.
Displays the interface's hardware information and its assigned MAC address.
Displays the encapsulation method, the framing, and if the
is enabled.
States whether the
scramble-atm
enabled.
States whether the loopback,
clock
configured.
This information is displayed over 2 lines.
Displays the number of seconds between keepalive messages.
States if LCP was successfully negotiated.
sonet
followed by the slot/port
TenGigabitEthernet
ais-shut
and the
down-when-looped
commands are
source, and speed, and
flag
commands are
command
Advertisement
