Advertisement
Parameters
interface
Defaults
No default behavior or values
Command Modes
EXEC
Command
Version 7.8.1.0
History
Version 7.4.1.0
Example
Figure 38-28. show ipv6 ospf interface command
FTOS#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
FTOS#
show ipv6 ospf neighbor
c e
Display the OSPF neighbor information on a per-interface basis.
Syntax
show ipv6 ospf neighbor [interface]
Added support for C-Series
Introduced
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a SONET interface, enter the keyword
port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
•
For a VLAN, enter the keyword
4094
Open Shortest Path First (OSPFv2 and OSPFv3) | 1083
port-channel
sonet
followed by the slot/
followed by the slot/port information.
vlan
followed by a number from 1 to
Advertisement
