Advertisement
track interface ipv6 routing
c e s
Configure object tracking on the routing status of an IPv6 Layer 3 interface.
Syntax
track object-id interface interface ipv6 routing
To return to the default setting, enter no track object-id.
Parameters
object-id
interface
Defaults
None
Command Modes
CONFIGURATION
Command
Version 8.4.1.0
History
Related
show track ipv6
Commands
route
track interface ip
routing
Usage
Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface:
Information
•
•
Enter the ID number of the tracked object. Range: 1 to 65535.
Enter one of the following values:
•
For a 1-Gigabit Ethernet interface, enter gigabitethernet slot-number/
port-number.
For a Loopback interface, enter loopback number, where number is from 0 to
•
16383.
For a Port Channel interface, enter port-channe
•
are:
C-Series and S-Series: 1 to 128
E-Series: 1 to 32 for EtherScale; 1 to 255 for TeraScale; 1 to 512 for ExaScale.
•
For SONET interfaces, enter the sonet slot-number/port-number.
For a 10-Gigabit Ethernet interface, enter tengigabitethernet slot-number/
•
port-number
For a VLAN interface, enter vlan number, where number is from 1 to 4094.
•
Introduced
Display information about tracked IPv6 routes, including configuration, current state, and
clients which track the route.
Configure object tracking on the routing status of an IPv4 Layer 3 interface.
The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the
interface has a valid IP address.
The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes down (for a
Layer 3 VLAN, all VLAN ports must be down) or the IP address is removed from the routing
table.
l
number, where the valid values
Object Tracking | 1001
Advertisement
