Advertisement
Related
Commands
interface null
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Example
Usage
Information
Related
Commands
574
|
Interfaces
If two RPMs are installed in your system, use the
the Primary RPM.
management route
duplex (Management)
speed (Management interface)
Configure a Null interface on the switch.
interface null number
number
Enter zero (0) as the Null interface number.
Not configured; number = 0
CONFIGURATION
Version 8.1.1.0
Introduced on E-Series ExaScale
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
Version 6.4.1.0
Introduced
Figure 23-8. interface null Command Example
FTOS(conf)#interface null 0
FTOS(conf-if-nu-0)#
You cannot delete the Null interface. The only configuration command possible in a Null interface is
unreachables.
interface
interface loopback
interface port-channel
interface vlan
ip unreachables
show redundancy
Configure a static route that points to the Management interface or a
forwarding router.
Clear FIB entries on a specified line card.
Clear FIB entries on a specified line card.
Configure a physical interface.
Configure a Loopback interface.
Configure a port channel.
Configure a VLAN.
Enable generation of ICMP unreachable messages.
command to display which RPM is
ip
Advertisement
