Dell Force10 TeraScale E Series Reference Manual page 1086

description
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Related
Commands
ip redirect-group
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
1086 | Policy-based Routing (PBR)
Add a description to this redirect list.
description {description}
To remove the description, use the no description {description} command.
description
Enter a description to identify the IP redirect list (80 characters maximum).
No default behavior or values
REDIRECT-LIST
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
pre-Version 7.7.1.0 Introduced on the E-Series ExaScale
ip redirect-list
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an
interface by entering this command multiple times.
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name command.
redirect-list-name
No default behavior or values
INTERFACE (conf-if-vl-)
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 7.4.2.0 Added support for LAG and VLAN interfaces
Version 6.5.3.0 Introduced on the E-Series ExaScale
Any number of redirect-groups can be applied to an interface. A redirect list can contain any number of
configured rules. These rules includes the next-hop IP address where the incoming traffic is to be
redirected.
Enable an IP Redirect List
Enter the name of a configured redirect list.