Advertisement
Parameters
Defaults
Command Modes
Command
History
Example
E-Series
Example
C-Series
storm-control broadcast (Configuration)
c e s
Syntax
1412
|
Storm Control
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
•
For a 1-Gigabit Ethernet interface, enter the keyword
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
by the slot/port information.
•
For a SONET interface, enter the keyword
•
Fast Ethernet is not supported.
No default behavior or values
EXEC
EXEC Privilege
Version 7.6.1.0
Introduced on S-Series
Version 7.5.10
Introduced on C-Series
Version 6.5.1.0
Introduced on E-Series
Figure 57-4. show storm-control unknown-unicast Command Example (E-Series)
FTOS#show storm-control unknown-unicast gigabitethernet 11/1
Unknown-unicast storm control configuration
Interface
Direction
--------------------------------------------------------------
Gi 11/1
Ingress
Gi 11/1
Egress
FTOS#
Figure 57-5. show storm-control unknown-unicast Command Example (C-Series)
FTOS#show storm-control unknown-unicast gigabitethernet 3/0
Unknown-unicast storm control configuration
Interface
Direction
-----------------------------------------------
Gi 3/0
Ingress
FTOS#
Configure the percentage of broadcast traffic allowed in or out of the network.
storm-control broadcast [percentage decimal_value in | out] | [wred-profile name]]
[packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value
in | out] | [wred-profile name]] [packets_per_second in] command.
GigabitEthernet
sonet
followed by the slot/port information.
Percentage
Wred Profile
5.9
-
5.7
w8
Packets/Second
1000
followed by the
TenGigabitEthernet
followed
Advertisement
