Advertisement
Parameters
cost
Defaults
The default cost is based on the reference bandwidth.
Command Modes
INTERFACE
Command
Version 7.6.1.0
History
Version 7.5.1.0
pre-Version 6.1.1.1
Usage
If this command is not configured, cost is based on the
Information
When you configure OSPF over multiple vendors, use the
routers use the same cost. Otherwise, OSPF routes improperly.
Related
auto-cost
Commands
ip ospf dead-interval
c e s
Set the time interval since the last hello-packet was received from a router. After the interval elapses,
the neighboring routers declare the router dead.
Syntax
ip ospf dead-interval seconds
To return to the default values, enter no ip ospf dead-interval.
Parameters
seconds
Defaults
40 seconds
Command Modes
INTERFACE
Command
Version 7.6.1.0
History
Version 7.5.1.0
pre-Version 6.1.1.1
Usage
By default, the dead interval is four times the default hello-interval.
Information
Related
ip ospf hello-interval
Commands
Enter a number as the cost.
Range: 1 to 65535.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Control how the OSPF interface cost is calculated.
Enter the number of seconds for the interval.
Range: 1 to 65535. Default: 40 seconds.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Set the time interval between hello packets.
auto-cost
command.
ip ospf cost
command to ensure that all
Open Shortest Path First (OSPFv2 and OSPFv3) | 1023
Advertisement
