Advertisement
Defaults
Command Modes
Command
History
Related
Commands
description
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Related
Commands
1166
|
Per-VLAN Spanning Tree plus (PVST+)
To enable PVST+, enter no disable.
PVST+ is disabled
CONFIGURATION (conf-pvst)
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
pre-Version 6.2.1.1
Introduced on E-Series
protocol spanning-tree pvst
Enter a description of the PVST+
description {description}
To remove the description, use the no description {description} command.
description
Enter a description to identify the Spanning Tree (80 characters maximum).
No default behavior or values
SPANNING TREE PVST+ (The prompt is "config-pvst".)
pre-7.7.1.0
protocol spanning-tree pvst
Enter PVST+ mode.
Introduced
Enter SPANNING TREE mode on the switch.
Advertisement
