Advertisement
permit
e
Configure a filter to pass IP packets meeting the filter criteria.
Syntax
permit {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask |
any | host ip-address} [count [byte]| log]
To remove this filter, you have two choices:
•
•
Parameters
ip
ip-protocol-number
source
mask
any
host ip-address
destination
count
byte
log
Defaults
Not configured.
Command Modes
TRACE LIST
Related
ip trace-list
Commands
permit tcp
permit udp
permit tcp
e
Configure a filter to pass TCP packets meeting the filter criteria.
Syntax
permit tcp {source mask | any | host ip-address} [operator port [port]] {destination mask |
any | host ip-address} [operator port [port]] [count [byte]] | log] [order number]
Use the no seq sequence-number command syntax if you know the filter's sequence number
or
Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Enter the keyword
specifies that the access list will permit all IP protocols.
Enter a number from 0 to 255 to permit based on the protocol identified in the
IP protocol header.
Enter the IP address of the network or host from which the packets were sent.
(OPTIONAL) Enter a network mask in /prefix format (/x).
Enter the keyword
Enter the keyword
address.
Enter the IP address of the network or host to which the packets are sent.
(OPTIONAL) Enter the keyword
filter.
(OPTIONAL) Enter the keyword
filter.
(OPTIONAL) Enter the keyword
Trace-list log file.
Create a trace list.
Assign a trace list filter to forward TCP packets.
Assign a trace list filter to forward UDP packets.
ip
to configure a generic IP access list. The keyword
any
to specify that all routes are subject to the filter.
host
followed by the IP address to specify a host IP
count
to count packets processed by the
byte
to count only bytes processed by the
log
to have the information kept in a
ip
Security | 1327
Advertisement
