Advertisement
Command
History
seq
c e s
Syntax
Parameters
1090
|
Policy-based Routing (PBR)
Version 8.4.2.1
Introduced on the C-Series and S-Series
Version 8.4.2.0
Introduced on the E-Series TeraScale
Version 7.4.1.0
Added the bit variable for TCP protocols only
Version 6.5.3.0
Introduced on the E-Series ExaScale
Configure a filter with an assigned sequence number for the redirect list.
seq sequence-number {permit | redirect {ip-address | sonet slot/port}} {ip-protocol-number
| protocol-type} {source mask | any | host ip-address} {destination mask | any | host
ip-address} [bit] [operator]
To delete a filter, use the no seq sequence-number command.
sequence-number
permit
redirect
ip-address
sonet slot/port
ip-protocol-number
protocol-type
source
mask
any
host ip-address
destination
Enter a number from 1 to 65535.
permit
Enter the keyword
assign the sequence to the permit list.
redirect
Enter the keyword
to assign the sequence to the redirect list.
Enter the IP address of the forwarding router.
sonet
Enter the keyword
followed by the slot/port information.
Enter a number from 0 to 255 for the protocol identified in the IP protocol
header.
Enter one of the following keywords as the protocol type:
icmp
•
for Internet Control Message Protocol
ip
•
for Any Internet Protocol
tcp
•
for Transmission Control Protocol
udp
•
for User Datagram Protocol
Enter the IP address of the network or host from which the packets were sent.
Enter a network mask in /prefix format (/x).
any
Enter the keyword
to specify that all traffic is subject to the filter.
host
Enter the keyword
followed by the IP address to specify a host IP
address.
Enter the IP address of the network or host to which the packets are sent.
Advertisement
