Advertisement
Command
History
Related
Commands
logging history
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
logging history size
c e s
Syntax
Parameters
Defaults
1376
|
SNMP and Syslog
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
E-Series legacy command
logging
Enable logging to a Syslog server.
logging on
Enables logging.
Specify which messages are logged to the history table of the switch and the SNMP network
management station (if configured).
logging history level
To return to the default values, enter no logging history.
level
Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications, informational, or
debugging.
The default is 4.
4 or warnings
CONFIGURATION
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
E-Series legacy command
When you configure the
snmp-server trap-source
table are also sent to the SNMP network management station.
show logging history
Display information logged to the history buffer.
Specify the number of messages stored in the FTOS logging history table.
logging history size size
To return to the default values, enter no logging history size.
size
Indicate a value as the number of messages to be stored.
Range: 0 to 500.
Default: 1 message.
1 message
command, the system messages logged to the history
Advertisement
