Advertisement
Command Modes
Command
History
Usage
Information
Related
Commands
redundancy force-failover stack-unit
s
Syntax
Defaults
Command Modes
reset stack-unit
s
Syntax
Parameters
Default
Command Modes
Command
History
Usage
Information
1402
|
S-Series Stacking Commands
CONFIGURATION
Version 8.3.1.0
Added the
Version 7.7.1.0
Introduced on S-Series
Enabling this command keeps the failed switch in the failed state. It will not reboot until it is manually
rebooted. When enabled, it is not displayed in the running-config. When disabled, it is displayed in the
running-config.
show redundancy
Force the backup unit in the stack to become the management unit.
redundancy force-failover stack-unit
Not enabled
EXEC Privilege
Reset any designated stack member except the management unit (master unit).
reset stack-unit 0-7 hard
0-7
Enter the stack member unit identifier of the stack member to reset.
hard
Reset the stack unit if the unit is in a problem state.
none
CONFIGURATION
Version 8.3.1.0
Added hard reset option.
Version 7.8.1.0
Augmented to run on the standby unit in order to reset the standby unit directly.
Version 7.7.1.0
Introduced on S-Series
Resetting the management unit is not allowed, and an error message will be displayed if you try to do
so. Resetting is a soft reboot, including flushing the forwarding tables.
Starting with FTOS 7.8.1.0, you can run this command directly on the stack standby unit (standby
master) to reset the standby. You cannot reset any other unit from the standby unit.
all
option
Display the current redundancy status.
Advertisement
