Advertisement
Usage
Sample-rate is the average number of packets skipped before the sample is taken. This command
Information
changes the global default sampling rate. You can configure an interface to use a different sampling
rate than the global sampling rate. If the value entered is not a correct power of 2, the command
generates an error message with the previous and next power of 2 value. Select one of these two packet
numbers and re-enter the command.
Related
sflow sample-rate (Interface)
Commands
sflow sample-rate (Interface)
c e s
Change the Interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, enter the no sflow sample-rate.
Parameters
value
Defaults
The Global default sampling
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.2.1.1
Usage
This command changes the sampling rate for an Interface. By default, the sampling rate of an interface
Information
is set to the same value as the current global default sampling rate. If the value entered is not a correct
power of 2, the command generates an error message with the previous and next power-of-2 value.
Select one of these two number and re-enter the command.
Related
sflow sample-rate (Global)
Commands
show sflow
c e s
Display the current sFlow configuration
show sflow [interface]
Syntax
Change the Interface sampling rate.
Enter the sampling rate value.
Range: C-Series and S-Series: 256 to 8388608 packets
E-Series TeraScale and ExaScale: 2 to 8388608 packets
Enter values in powers of 2 only, for example 4096, 8192, 16384 etc.
Default: 32768 packets
Introduces on S-Series Stacking
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Change the sampling rate globally.
sFlow | 1351
Advertisement
