Advertisement
match mac vlan
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
1196
|
Quality of Service (QoS)
Configure a match criterion for a class map based on a VLAN ID.
match mac vlan {vlan-id | vlan-list | vlan-range | mixed-vlan-list}
vlan-id
vlan-list
vlan-range
mixed-vlan-list
None
CLASS-MAP
Version 8.4.2.4
Support for multiple VLAN IDs as match criteria was introduced on the S25 and S50.
Version 8.2.0.1
Introduced.
You must first enter the class-map command in order to access this command. In a class map, you
can match and classify traffic using a VLAN ID.
Note:
The use of multiple VLAN IDs (VLAN list or range) as match criteria in a class map is
supported only on the S25 and S50.
class-map
Enter the VLAN ID. Valid VLAN IDs are from 1 to 4094
S25 and S50 only: Enter two or more VLAN IDs separated by a comma:
vlan-id,vlan-id,vlan-id,...
For example: match mac vlan 2,4,6
There is no space between VLAN IDs and the comma.
S25 and S50 only: Enter a range VLAN IDs separated by a dash (-):
vlan-id-vlan-id
For example: match mac vlan 3-5
There is no space between VLAN IDs and the comma.
S25 and S50 only: Enter single VLAN IDs and VLAN ranges in any order:
vlan-id,vlan-range,vlan-id...
For example: match mac vlan 1,3-5,8
Create/access a class map.
Advertisement
