Dell Force10 TeraScale E Series Reference Manual page 1326

ip trace-group
e
Syntax
Parameters
Defaults
Command Modes
Usage
Information
Related
Commands
ip trace-list
e
Syntax
Parameters
Defaults
Example
Command Modes
Usage
Information
Related
Commands
1326 | Security
Assign a trace list globally to process all incoming packets to the switch.
ip trace-group trace-list-name
To delete an trace list configuration, use the no ip trace-group trace-list-name command.
trace-list-name
Enter the name of a configured trace list.
Not enabled.
CONFIGURATION
You can assign one Trace list to the chassis.
If there are unresolved next-hops and a Trace-list is enabled, there is a possibility that the traffic hitting
the CPU will not be rate-limited.
ip trace-list Configure a trace list ACL.
Configure a trace list, based on IP addresses or protocols, to filter all traffic on the E-Series.
ip trace-list trace-list-name
To delete a trace list, use the no ip trace-list trace-list-name command.
trace-list-name Enter a string up to 16 characters long as the access list name.
Not configured
Figure 51-15. ip trace-list Command Example
FTOS(conf)#ip trace-list suzanne
FTOS(config-trace-acl)#
CONFIGURATION
After you create a trace list, you must apply it to the E-Series using the
CONFIGURATION mode.
ip trace-group View the current configuration.
ip trace-group command in the