Advertisement
OSPFv3 Commands
Open Shortest Path First version 3 (OSPFv3) for IPv6 is supported on the
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, etc.)
remain unchanged. However, OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis.
Most changes were necessary to handle the increased address size of IPv6.
The Dell Force10 implementation of OSPFv3 is based on IETF RFC 2740. The following commands
allow you to configure and enable OSPFv3.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Note:
The C-Series supports OSPFv3 with FTOS version 7.8.1.0 and later.
area authentication
area encryption
clear ipv6 ospf process
debug ipv6 ospf packet
default-information originate
graceful-restart grace-period
graceful-restart mode
ipv6 ospf area
ipv6 ospf authentication
ipv6 ospf cost
ipv6 ospf dead-interval
ipv6 ospf encryption
ipv6 ospf graceful-restart helper-reject
ipv6 ospf hello-interval
ipv6 ospf priority
ipv6 router ospf
passive-interface
redistribute
router-id
show crypto ipsec policy
show crypto ipsec sa ipv6
show ipv6 ospf database
show ipv6 ospf interface
show ipv6 ospf neighbor
c
Open Shortest Path First (OSPFv2 and OSPFv3) | 1063
e
and
platforms.
Advertisement
