Advertisement
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
Version 7.4.1.0
History
Usage
The RP addresses are stored in the order in which they are entered. RP addresses learnt via BSR take
Information
priority over static RP addresses.
Without the override option, RPs advertised by the BSR updates take precedence over the statically
configured RPs.
ipv6 pim rp-candidate
e
Specify an interface as an RP candidate.
Syntax
ipv6 pim rp-candidate interface [priority-value]
Parameters
interface
priority-value
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
Version 7.4.1.0
History
Introduced
Enter the following keywords and slot/port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Loopback interface, enter the keyword
from 0 to 16383.
•
For a Port Channel interface, enter the keyword
number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a VLAN, enter the keyword
(OPTIONAL) Enter a number as the priority of this RP Candidate, which is included
in the Candidate-RP-Advertisements.
Range: 0 (highest) to 255 (lowest)
Introduced
GigabitEthernet
loopback
followed by a number
port-channel
TenGigabitEthernet
vlan
followed by a number from 1 to 4094.
PIM-Sparse Mode (PIM-SM) | 1125
followed by a
Advertisement
