Advertisement
SNMP and Syslog
Overview
This chapter contains commands to configure and monitor SNMP v1/v2/v3 and Syslog. Both features
are supported on the C-Series, E-Series, and S-Series platforms, as indicated by the following symbols
under each of the command headings:
The chapter contains the following sections:
•
•
SNMP Commands
The SNMP commands available in FTOS are:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The Simple Network Management Protocol (SNMP) is used to communicate management information
between the network management stations and the agents in the network elements. FTOS supports
SNMP versions 1, 2c, and 3, supporting both read-only and read-write modes. FTOS sends SNMP
traps, which are messages informing an SNMP management system about the network. FTOS supports
up to 16 SNMP trap receivers.
SNMP Commands
Syslog Commands
show snmp
show snmp engineID
show snmp group
show snmp user
snmp ifmib ifalias long
snmp-server community
snmp-server contact
snmp-server enable traps
snmp-server engineID
snmp-server group
snmp-server host
snmp-server location
snmp-server packetsize
snmp-server trap-source
snmp-server user
snmp-server view
snmp trap link-status
c e s
54
SNMP and Syslog | 1355
Advertisement
