Advertisement
Usage
Information
show cam layer2-qos
e
Syntax
Parameters
Defaults
Command Modes
Command
History
1208
|
Quality of Service (QoS)
Version 7.4.1.0
E-Series Only: Expanded to add support for mac-dot1p
pre-Version 6.1.1.1
Introduced on E-Series
C-Series and S-Series
Once the IP DSCP bit is set, other QoS services can then operate on the bit settings.
E-Series
Once the IP DSCP bit is set, other QoS services can then operate on the bit settings. WRED (Weighted
Random Early Detection) ensures that high-precedence traffic has lower loss rates than other traffic
during times of congestion.
Display the Layer 2 QoS CAM entries.
show cam layer2-qos {[linecard number port-set number] | [interface interface]}
[summary]
linecard number
port-set number
interface interface
summary
No default behavior or values
EXEC
Version 7.4.1.0
Introduced on E-Series
linecard
Enter the keyword
followed by the line card slot number.
E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a
E300.
port-set
Enter the keyword
followed by the line card's port pipe.
Range: 0 or 1
interface
Enter the keyword
slot/port or number information:
•
For a Fast Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a SONET interface, enter the keyword
port information.
•
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
(OPTIONAL) Enter the keyword
number of CAM entries.
followed by one of the keywords below and
FastEthernet
GigabitEthernet
sonet
followed by the slot/
summary
to display only the total
Advertisement
