Advertisement
threshold
e
Specify the minimum and maximum threshold values for the configured WRED profiles.
Syntax
threshold min number max number
To remove the threshold values, use the no threshold min number max number command.
Parameters
min number
max number
Defaults
No default behavior or values
Command Modes
CONFIGURATION (config-wred)
Command
pre-Version 6.1.1.1
History
Usage
Use this command to configure minimum and maximum threshold values for user defined profiles.
Information
Additionally, use this command to modify the minimum and maximum threshold values for the
pre-defined WRED profiles. If you delete threshold values of the pre-defined WRED profiles, the
profiles will revert to their original default values.
Table 47-8. Pre-defined WRED Profile Threshold Values
Pre-defined WRED Profile Name
wred_drop
wred_ge_y
wred_ge_g
wred_teng_y
wred_teng_g
Related
wred-profile
Commands
trust
c e s
Specify dynamic classification (DSCP) or dot1p to trust.
Syntax
trust {diffserv [fallback]| dot1p [fallback]| ipv6-diffserv}
Parameters
diffserv
dot1p
Enter the keyword
WRED profile.
Range: 1024 to 77824 KB
Enter the keyword
WRED profile.
Range: 1024 to 77824 KB
Introduced on E-Series
Minimum Threshold
0
1024
2048
4096
8192
Create a WRED profile.
diffserv
Enter the keyword
dot1p
Enter the keyword
to specify trust dot1p configuration.
min
followed by the minimum threshold number for the
max
followed by the maximum threshold number for the
Maximum Threshold
0
2048
4096
8192
16384
to specify trust of DSCP markings.
Quality of Service (QoS) | 1221
Advertisement
