Advertisement
dot1x authentication (Configuration)
c e s
Syntax
Defaults
Command Modes
Command
History
Related
Commands
dot1x authentication (Interface)
c e s
Syntax
Defaults
Command Modes
Command
History
Related
Commands
1304
|
Security
•
If 802.1X authorization is enabled and all information from the RADIUS server is valid, the port is
placed in the specified VLAN after authentication.
•
If port security is enabled on an 802.1X port with VLAN assignment, the port is placed in the
RADIUS server assigned VLAN.
•
If 802.1X is disabled on the port, it is returned to the configured access VLAN.
•
When the port is in the force authorized, force unauthorized, or shutdown state, it is placed in the
configured access VLAN.
•
If an 802.1X port is authenticated and put in the RADIUS server assigned VLAN, any change to
the port access VLAN configuration will not take effect.
•
The 802.1X with VLAN assignment feature is not supported on trunk ports, dynamic ports, or
with dynamic-access port assignment through a VLAN membership.
Enable dot1x globally; dot1x must be enabled both globally and at the interface level.
dot1x authentication
To disable dot1x on an globally, use the no dot1x authentication command.
Disabled
CONFIGURATION
Version 7.6.1.0
Version 7.4.1.0
dot1x authentication (Interface)
Enable dot1x on an interface; dot1x must be enabled both globally and at the interface level.
dot1x authentication
To disable dot1x on an interface, use the no dot1x authentication command.
Disabled
INTERFACE
Version 7.6.1.0
Version 7.4.1.0
dot1x authentication (Configuration)
Introduced on C-Series and S-Series
Introduced on E-Series
Enable dot1x on an interface
Introduced on C-Series and S-Series
Introduced on E-Series
Enable dot1x globally
Advertisement
