Advertisement
Usage
To enable RIP, you must assign a network address using the
Information
Figure 48-1. router rip Command Example
Example
FTOS(conf)#router rip
FTOS(conf-router_rip)#
Related
network
Commands
exit
show config
c e s
Display the changes you made to the RIP configuration. Default values are not shown.
show config
Syntax
Command Modes
ROUTER RIP
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Example
Figure 48-2. show config Command Example in ROUTER RIP Mode
FTOS(conf-router_rip)#show config
!
router rip
FTOS(conf-router_rip)#
show ip rip database
c e s
Display the routes learned by RIP. If the switch learned no RIP routes, no output is generated.
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address
mask
Command Modes
EXEC Privilege
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Enable RIP.
Return to the CONFIGURATION mode.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
network 172.31.0.0
passive-interface
GigabitEthernet 0/1
(OPTIONAL) Specify an IP address in dotted decimal format to view RIP information on
that network only.
If you enter an IP address, you must also enter a mask for that IP address.
(OPTIONAL) Specify a mask, in /network format, for the IP address.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
network
command.
Router Information Protocol (RIP) | 1249
Advertisement
