Advertisement
Storm Control
Overview
The FTOS Storm Control feature allows users to limit or suppress traffic during a traffic storm
(Broadcast/Unknown Unicast Rate Limiting, or Multicast on the C-Series and S-Series).
Support for particular Dell Force10 platforms (C-Series, E-Series, or S-Series) is indicated by the
characters that appear below each command heading:
•
•
•
Commands
The Storm Control commands are:
•
•
•
•
•
•
•
•
•
Important Points to Remember
•
•
•
•
•
c
C-Series:
e
E-Series:
s
S-Series:
show storm-control broadcast
show storm-control multicast
show storm-control unknown-unicast
storm-control broadcast (Configuration)
storm-control broadcast (Interface)
storm-control multicast (Configuration)
storm-control multicast (Interface)
storm-control unknown-unicast (Configuration)
storm-control unknown-unicast (Interface)
Interface commands can only be applied on physical interfaces (VLANs and LAG interfaces are
not supported).
An INTERFACE-level command only support storm control configuration on ingress.
An INTERFACE-level command overrides any CONFIGURATION-level ingress command for
that physical interface, if both are configured.
The CONFIGURATION-level storm control commands can be applied at ingress or egress and are
supported on all physical interfaces.
When storm control is applied on an interface, the percentage of storm control applied is
calculated based on the advertised rate of the line card. It is not based on the speed setting for the
line card.
57
Storm Control | 1409
Advertisement
