Advertisement
Related
Commands
stack-unit priority
s
Syntax
Parameters
Defaults
Command Modes
Command
History
Related
Commands
1406
|
S-Series Stacking Commands
Table 56-1. show interfaces description Command Example Fields
Field
Description
Link Speed
Link Speed of the stack port (12 or 24) in Gb/s
Admin
The only currently listed status is Up.
Status
Connection
The stack port ID to which this unit's stack port is connected
reset stack-unit
show hardware stack-unit
show system (S-Series)
upgrade (S-Series
management unit)
Configure the ability of an S-Series switch to become the management unit of a stack.
stack-unit 0-7 priority 1-14
0-7
Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to set the
management priority.
1-14
This preference parameter allows you to specify the management priority of one backup switch
over another, with 0 the lowest priority and 14 the highest.
The switch with the highest priority value will be chosen to become the management unit if the
active management unit fails or on the next reload.
1
CONFIGURATION
Version 7.7.1.0
Introduced on S-Series
reload
show system (S-Series)
Reset the designated S-Series stack member.
Display the data plane or management plane input and output statistics of the
designated component of the designated stack member.
Display the current status of all stack members or a specific member.
Upgrade the bootflash image or system image of the S-Series management
unit.
Reboot FTOS.
Display the current status of all stack members or a specific member.
Advertisement
