Advertisement
multiplier
c e s
Set the number of consecutive misses before LLDP declares the interface dead.
multiplier integer
Syntax
To return to the default, use the no multiplier integer command.
Parameters
integer
Defaults
4 x hello
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
Version 7.7.1.0
History
Version 7.6.1.0
Version 7.4.1.0
protocol lldp (Configuration)
c e s
Enable LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults
Disabled
Command Modes
CONFIGURATION (conf-lldp)
Command
Version 7.7.1.0
History
Version 7.6.1.0
Version 7.4.1.0
protocol lldp (Interface)
c e s
Enter the LLDP protocol in the INTERFACE mode.
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command from the
Interface mode.
Defaults
LLDP is not enabled on the interface.
Command Modes
INTERFACE (conf-if-interface-lldp)
Command
Version 7.7.1.0
History
Enter the number of consecutive misses before the LLDP declares the interface dead.
Range: 2 - 10
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Introduced on S-Series
Link Layer Detection Protocol (LLDP) | 903
Advertisement
