Advertisement
Example
Related
Commands
Port Channel Commands
616
|
Interfaces
Figure 23-42. wanport Command with shutdown Command Example
interface TenGigabitEthernet 13/0
no ip address
no shutdown
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#wanport
% Error: Port should be in shutdown mode, config ignored Te 13/0.
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#shutdown
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#wanport
FTOS(conf-if-te-13/0)#
ais-shut
alarm-report
clock source
down-when-looped
flag
framing
keepalive
loopback
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a
single link according to IEEE 802.3ad. In FTOS, a LAG is referred to as a Port Channel.
Table 23-11. Port Channel Limits
Platform
E-Series ExaScale
E-Series TeraScale
E-Series EtherScale
C-Series
S-Series
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least
one port, some of those nominally available Port Channels might have no function because they could
have no members if there are not enough ports installed. In the S-Series, those ports could be provided
by stack members.
The commands in this section are specific to Port Channel interfaces:
•
channel-member
•
group
•
interface port-channel
•
minimum-links
•
port-channel failover-group
•
show config
Send LAIS on shutdown
Enable reporting of a selected alarm
Configure a clock source
Send a message when a loopback condition is detected
Set flags to ensure interoperability
Set framing type
Enable keepalive
Troubleshoot a SONET loopback
Maximum Port Channel
IDs
255
255
32
128
128
Maximum Members per Port
Channel
64
16
16
8
8
Advertisement
