Advertisement
Related
Commands
ipv6 ospf cost
c e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
ipv6 ospf dead-interval
c e
Syntax
Parameters
Defaults
Command Modes
1072
|
Open Shortest Path First (OSPFv2 and OSPFv3)
-
area encryption
show crypto ipsec policy
show crypto ipsec sa ipv6
Explicitly specify the cost of sending a packet on an inter.
ipv6 ospf cost interface-cost
To reset the interface cost to the default value, use the no ipv6 ospf cost interface-cost command.
interface-cost
Default cost based on the bandwidth
INTERFACE
Version 7.8.1.0
Added support for C-Series
Version 7.4.1.0
Introduced
In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost are calculated as:
•
GigabitEthernet—Default cost is 1
•
TenGigabitEthernet—Default cost is 1
•
Ethernet—Default cost is 10
Set the time interval since the last hello-packet was received from a router. After the time interval
elapses, the neighboring routers declare the router down.
ipv6 ospf dead-interval seconds
To return to the default time interval, use the no ipv6 ospf dead-interval command.
seconds
As above
INTERFACE
Configure an IPsec encryption policy for an OSPFv3 area.
isplay the configuration of IPsec encryption policies.
D
isplay the security associations set up for OSPFv3 interfaces
D
in encryption policies.
Enter a unsigned integer value expressed as the link-state metric.
Range: 1 to 65535
Enter the time interval in seconds.
Range: 1 to 65535 seconds
Default: 40 seconds (Ethernet)
Advertisement
