Advertisement
match ip access-group
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
description
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
1192
|
Quality of Service (QoS)
Configure match criteria for a class map, based on the access control list (ACL).
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, enter no match ip access-group
access-group-name [set-ip-dscp value] command.
access-group-name
set-ip-dscp value
No default behavior or values
CLASS-MAP CONFIGURATION (config-class-map)
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.5.1.0
pre-Version 6.1.1.1
You must enter the class-map command in order to access this command. Once the class map is
identified, you can configure the match criteria. For class-map match-any, a maximum of five
ACL match criteria are allowed. For class-map match-all, only one ACL match criteria is allowed.
class-map
Add a description to the selected policy map or QOS policy.
description {description}
To remove the description, use the no description {description} command.
description
Enter a description to identify the policies (80 characters maximum).
No default behavior or values
CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and
conf-qos-policy-out; wred)
pre-Version 7.7.1.0
Introduced
Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by
(OPTIONAL) Enter the keyword
value. The matched traffic will be marked with the DSCP value.
Range: 0 to 63
Added DSCP Marking option support on S-Series
Introduced on S-Series
Introduced on C-Series
Added support for DSCP Marking option
Introduced on E-Series
Identify the class map.
class-map
set-ip-dscp
followed by the IP DSCP
.
Advertisement
