Advertisement
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.1
Usage
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
Information
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
If you delete all the
Area 0.
Figure 38-6. Command Example: show ip ospf process-id
Example
FTOS>show ip ospf 1
Routing Process ospf 1 with ID 11.1.2.1
Supports only single TOS (TOS0) routes
It is an autonomous system boundaryrouter
SPF schedule delay 0 secs, Hold time between two SPFs 5 secs
Number of area in this router is 1, normal 1 stub 0 nssa 0
FTOS>
Table 38-2. Command Output Descriptions: show ip ospf process-id
Line Beginning with
"Routing Process..."
"Supports only..."
"SPF schedule..."
"Number of..."
Related
show ip ospf database
Commands
show ip ospf interface
show ip ospf neighbor
show ip ospf virtual-links
show ip ospf asbr
c e s
Display all ASBR routers visible to OSPF.
Syntax
show ip ospf process-id asbr
Parameters
process-id
Defaults
No default values or behavior
Command Modes
EXEC
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
network area
Area BACKBONE (0.0.0.0)
Number of interface in this area is 2
SPF algorithm executed 4 times
Area ranges are
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
commands for Area 0, the
show ip ospf
Description
Displays the OSPF process ID and the IP address associated with the
process ID.
Displays the number of Type of Service (TOS) rouse supported.
Displays the delay and hold time configured for this process ID.
Displays the number and type of areas configured for this process ID.
Displays information about the OSPF routes configured.
Displays the OSPF interfaces configured.
Displays the OSPF neighbors configured.
Displays the OSPF virtual links configured.
Open Shortest Path First (OSPFv2 and OSPFv3) | 1037
command output will not list
Advertisement
