Dell Force10 TeraScale E Series Reference Manual page 1183

Ftos command line, ftos 8.4.2.7

C-Series and S-Series

On one interface, you can configure the

commands specifying different VLANS.

On one interface, you can configure the rate limit or

configure the rate limit or the

For each physical interface, you can configure six

After configuring VLANs in the

%Error: Specified VLANs overlap with existing config.

Check to see if the same VLANs are used with the rate limit command on other interfaces. To clear

the problem, remove the rate limit configuration(s), and re-configure the

configuration.

Shape the traffic output on the selected interface.

rate shape [kbps] rate [burst-KB]

Granularity for rate is Mbps unless the kbps option is used.

Command Modes

Version 8.2.1.0

Version 7.6.1.0

pre-Version 6.1.1.1

On 40-port 10G line cards, if the traffic is shaped between 64 and 1000kbs, for some values the shaped

rate is much less than the value configured. Do not use values in this range for 10G interfaces.

command for an interface. For each physical interface, you can configure three

command is configured, return to the other interfaces and re-apply the rate limit

Police traffic output as part of the designated policy.

Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On

C-Series and S-Series make the following value a multiple of 64. The default

granularity is Megabits per second (Mbps).

Range: 0-10000000

Enter the outgoing rate in multiples of 10 Mbps.

Range: 10 to 10000

(OPTIONAL) Enter a number as the burst size in KB.

Range: 0 to 10000

Introduced on S-Series and on C-Series

Introduced on E-Series

command for a VLAN or you can configure the

command for the interface.

command, if this error message appears:

option on C-Series, E-Series, and Series.

command for a VLAN or you can

commands specifying different VLANS.

command. After

Quality of Service (QoS) | 1183