Advertisement
ip pim rp-address
c e s
Configure a static PIM Rendezvous Point (RP) address for a group or access-list.
Syntax
ip pim rp-address address { group-address group-address mask} override
To remove an RP address, use the no ip pim rp-address address { group-address
group-address mask} override command.
Parameters
address
group-address
group-address mask
override
Defaults
Not configured
Command Modes
CONFIGURATION
Command
Version 8.1.1.0
History
Version 7.8.1.0
pre-Version 6.1.1.1
Usage
This address is used by first-hop routers to send Register packets on behalf of source multicast hosts.
Information
The RP addresses are stored in the order in which they are entered. RP addresses learned via BSR take
priority over static RP addresses. Without the override option, RPs advertised by the BSR updates take
precedence over the statically configured RPs.
Enter the RP address in dotted decimal format (A.B.C.D).
group-address
Enter the keyword
dotted decimal format (/xx), to assign that group address to the RP.
override
Enter the keyword
The override will take effect immediately during enable/disable.
Note: This option is applicable to multicast group range.
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on E-Series
followed by a group-address mask, in
to override the BSR updates with static RP.
PIM-Sparse Mode (PIM-SM) | 1105
Advertisement
