Dell Force10 TeraScale E Series Reference Manual page 1243

Defaults
Enabled
Command Modes INTERFACE
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Related
ip poison-reverse
Commands
maximum-paths
c e s
Set RIP to forward packets over multiple paths.
Syntax maximum-paths number
To return to the default values, enter no maximum-paths.
Parameters
number
Defaults
4
Command Modes ROUTER RIP
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Usage RIP supports a maximum of 16 ECMP paths.
Information
neighbor
c e s
Define a neighbor router with which to exchange RIP information.
Syntax neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address
Defaults Not configured.
Command Modes
ROUTER RIP
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Set the prefix for RIP routing updates.
Enter the number of paths.
Range: 1 to 16.
The default is 4 paths.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Enter the IP address, in dotted decimal format, of a router with which to exchange
information.
Router Information Protocol (RIP) | 1243