Advertisement
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
Version 7.6.1.0
History
Version 7.5.1.0
snmp-server enable traps
c e s
Enable and configure SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-option]
command.
Parameters
notification-type
notification-option
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
Version 8.4.2.5
History
Version 8.4.1.3
Version 8.4.1.0
Version 7.6.1.0
Support added for S-Series
Support added for C-Series
E-Series legacy command
Enter the type of notification from the list below:
bgp—
•
Notification of changes in BGP process
envmon
•
—For Dell Force10, device notifications when an environmental
threshold is exceeded
snmp
•
—Notification of RFC 1157 traps.
stp
•
—Notification of state change in Spanning Tree protocol (RFC 1493)
vrrp
•
—Notification of state change in a VRRP group
xstp
•
—Notification of state change in MSTP (802.1s), RSTP (802.1w), and
PVST+
envmon
For the
notification-type, enter one of the following optional
parameters:
•
fan
•
supply
•
temperature
snmp
For the
notification-type, enter one of the following optional parameters:
•
authentication
•
coldstart
•
linkdown
•
linkup
New format for VRRP traps was introduced on the C-Series. New STP, RSTP, and
PVST+ traps for root and topology changes were added on the C-Series.
New format for VRRP traps was introduced on the E-Series ExaScale. New STP, RSTP,
and PVST+ traps for root and topology changes were added on the E-Series ExaScale.
Support was added for VRRP traps.
Support added for S-Series; Added support for STP and xSTP traps.
SNMP and Syslog | 1361
Advertisement
