Advertisement
Related
Commands
service-class dynamic dot1p
c e s
Syntax
Defaults
Command Modes
Command
History
Usage
Information
1184
|
Quality of Service (QoS)
rate-shape
Shape traffic output as part of the designated policy.
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or
on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes
INTERFACE mode entries.
service-class dynamic dot1p
To return to the default setting, enter no service-class dynamic dot1p.
All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled. Then the
default mapping is as follows:
Table 47-1. Default dot1p to Queue Mapping
dot1p
INTERFACE
CONFIGURATION (C-Series and S-Series only)
Version 8.2.1.0
Available globally on the C-Series and S-Series so that the configuration applies to all
ports.
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
Version 6.5.1.0
Expanded command to permit configuration on port channels
pre-Version 6.1.1.1
Introduced on E-Series
Enter this command to honor all incoming 802.1p markings, on incoming switched traffic, on the
interface. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic are
not honored).
This command can be applied on both physical interfaces and port channels. When you set the
service-class dynamic for a port channel, the physical interfaces assigned to the port channel are
automatically configured; you cannot assign the service-class dynamic command to individual
interfaces in a port channel.
E-Series
C-Series
Queue ID
Queue ID
0
2
1
0
2
1
3
3
4
4
5
5
6
6
7
7
S-Series
Queue ID
1
1
0
0
0
0
1
1
2
2
2
2
3
3
3
3
Advertisement
