Dell Force10 TeraScale E Series Reference Manual page 1246

Usage
Information
passive-interface
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
redistribute
c e s
Syntax
1246 | Router Information Protocol (RIP)
This command is intended for low-speed interfaces.
Suppress routing updates on a specified interface.
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
interface Enter the following information:
• For a 1-Gigabit Ethernet interface, enter the keyword
by the slot/port information.
• For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a VLAN, enter the keyword
Not configured.
ROUTER RIP
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Although the passive interface will neither send nor receive routing updates, the network on that
interface will still be included in RIP updates sent via other interfaces.
neighbor Enable RIP for a specified network.
network Define a neighbor.
Redistribute information from other routing instances.
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
GigabitEthernet
port-channel
sonet
followed by the slot/port
TenGigabitEthernet
vlan
followed by a number from 1 to 4094.
followed
followed by a