Advertisement
Related
Commands
clear ipv6 ospf process
ce
Syntax
Parameters
Command Modes
Command
History
debug ipv6 ospf packet
c e
Syntax
Parameters
Command Modes
1066
|
Open Shortest Path First (OSPFv2 and OSPFv3)
The configuration of IPsec encryption on an interface-level takes precedence over an area-level
configuration. If you remove an interface configuration, an area encryption policy that has been
configured is applied to the interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi
number command.
-
ipv6 ospf encryption
show crypto ipsec policy
Reset an OSPFv3 router process without removing or re-configuring the process.
clear ipv6 ospf process [process-id]
process-id
(OPTIONAL) Enter the process identification number.
EXEC
EXEC Privilege
Version 7.8.1.0
Added support for C-Series
Version 7.4.1.0
Introduced
Display debug information on OSPF IPv6 packets.
debug ipv6 ospf packet [interface]
To cancel the debug, use the no debug ipv6 ospf packet [interface] command.
interface
EXEC Privilege
Configure an IPsec encryption policy on an OSPFv3 interface.
isplay the configuration of IPsec encryption policies.
D
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a SONET interface, enter the keyword
port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
•
For a VLAN, enter the keyword
4094
port-channel
sonet
followed by the slot/
vlan
followed by a number from 1 to
Advertisement
