Advertisement
source (port monitoring)
c e s
Configure a port monitor source.
Syntax
source interface destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface direction {rx | tx
| both} command.
Parameters
interface
destination
direction {rx | tx | both}
Defaults
No default behavior or values
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
Version 8.1.1.0
History
Version 7.7.1.0
Version 7.5.1.0
Version 7.4.1.0
Example
Figure 44-4. Command Example: Configuring a Port Monitor Source
FTOS(conf-mon-sess-11)#source gi 10/0 destination gi 10/47 direction rx
FTOS(conf-mon-sess-11)#
Usage
Information
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Note:
A SONET port can only be configured as a monitored port.
Enter the one of the following keywords and slot/port information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
•
For a SONET interface, enter the keyword
slot/port information.
destination
Enter the keyword
direction
Enter the keyword
indicators.
rx
: to monitor receiving packets only
tx
: to monitor transmitting packets only
both
: to monitor both transmitting and receiving packets
followed by the slot/port information.
sonet
followed by the
to indicate the interface destination.
followed by one of the packet directional
Port Monitoring | 1149
Advertisement
