Advertisement
Defaults
Command Modes
Command
History
Usage
Information
ipv6 pim register-filter
e
Syntax
Parameters
Defaults
Command Modes
Command
History
Example
ipv6 pim rp-address
e
Syntax
Parameters
1124
|
PIM-Sparse Mode (PIM-SM)
None
CONFIGURATION
Version 8.3.1.0
Introduced
Do not enter this command before creating the access-list.
Configure the source DR so that it does not send register packets to the RP for the specified sources
and groups.
ipv6 pim register-filter access-list
access-list
Enter the name of the extended ACL that contains the sources and groups to be
filtered.
None
CONFIGURATION
Version 8.3.1.0
Introduced
FTOS(conf)#ipv6 pim register-filter REG-FIL_ACL
FTOS(conf)#ipv6 access-list REG-FIL_ACL
FTOS(conf-ipv6-acl)#deny ipv6 165:87:34::10/128 ff0e::225:1:2:0/112
FTOS(conf-ipv6-acl)#permit ipv6 any any
FTOS(conf-ipv6-acl)#exit
Configure a static PIM Rendezvous Point (RP) address for a group. This address is used by first-hop
routers to send Register packets on behalf of the source multicast host.
ipv6 pim rp-address address group-address group-address mask override
To remove an RP address, use the no ipv6 pim re-address address group-address mask
override.
address
group-address
group-address mask
override
Enter the IPv6 RP address in the
::
The
notation specifies successive hexadecimal fields of zero.
group-address
Enter the keyword
x:x:x:x::x
format and then the mask in /nn format to assign that group
address to the RP.
::
The
notation specifies successive hexadecimal fields of zero.
override
Enter the keyword
to override the BSR updates with static RP.
The override will take effect immediately during enable/disable.
Note: This option is applicable to multicast group range.
x:x:x:x::x
format.
followed by the group address in the
Advertisement
