ball joint from rotating.
Attach the stabilizer bar connecting link to the
beam axle on both sides.
Vehicles without anti-lock brakes
6. Attach the brake load sensor proportioning valve
to the beam axle.
All vehicles
7.
NOTE: Do not fully tighten the shock
absorber retaining nuts at this stage.
Attach the shock absorbers to the beam axle.
8. Remove the
securing
9. Lower and remove the
10. Install the brake backing plates. For additional
information, refer to Section
Brake.
11. Tighten the spring U-bolt retaining nuts.
12.
NOTE: Use a 6 mm Allen key to prevent the
ball joint from rotating.
Tighten the stabilizer bar connecting link to
beam axle retaining nuts.
http://vnx.su
strap.
transmission
jack.
206-02 Drum