Ford Transit 2002 Owner's Manual page 755

Using suitable retaining
engine and transaxle assembly on the
table and position it under the vehicle.
4. Install the engine rear mount.
5. Install the engine front mount.
6. Check the lower arm ball joint heat shield.
For additional information, refer to:
Ball Joint (204-01 Front Suspension, Removal
and Installation).
7. Using a suitable transmission jack, position and
raise the crossmember until the crossmember is
approximately 100 mm from the body.
8. Install new power steering line O-ring seals.
For additional information, refer to:
Steering System Flushing - 1.8L Duratorq-TDCi
(Lynx) Diesel/1.8L Duratorq-TDDi (Lynx) Diesel
(211-00 Steering System - General Information,
General Procedures).
9. Attach the power steering line to the steering
gear (crossmember shown removed for clarity).
1. Rotate the clamp clockwise.
2. Install the bolt.
http://vnx.su
straps, secure the
workshop
Lower Arm
Power