Ford Transit 2002 Owner's Manual page 937

line will show signs of fuel escaping.
Operate the hand pressure pump special tool and
tighten the high-pressure fuel supply line union
which shows signs of fuel escaping.
NOTE: Only turn the engine in the normal
15.
direction of rotation.
Using the paint mark as a reference, slowly turn
the engine through 180 degrees.
16. Repeat steps 14 and 15 to bleed the three
remaining high-pressure fuel supply lines.
17. Remove the lint-free material from the
generator.
CAUTION: Do not operate the starter
18.
motor for more than 10 seconds at a time.
After 10 seconds, turn the ignition switch to
position 0 and allow the starter motor to cool
for 30 seconds before attempting to start the
engine again.
Start the engine and allow it to idle until it
reaches normal operating temperature.
19. Switch the engine off.
20. Remove the hand pressure pump special tool
from the hand pressure pump special tool
adapter on the fuel tank to fuel filter fuel supply
line.
21. Remove the hand pressure pump special tool
adapter from the fuel tank to fuel filter fuel
supply line.
22. Remove the hand pressure pump special tool
from the hand pressure pump special tool
adapter on the fuel filter.
http://vnx.su