16.
CAUTION: If brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
Disconnect the clutch slave cylinder hydraulic
fluid supply line from the transaxle.
Remove the spring clip.
17. Disconnect the reversing lamp switch electrical
connector.
18. Disconnect the catalyst monitor sensor electrical
connector.
19. Disconnect the heated oxygen (HO2S) sensor
electrical connector.
20. Drain the cooling system. For additional
information, refer to Section
Cooling.
21. Remove the accessory drive belt. For additional
information, refer to Section
Drive.
http://vnx.su
303-03 Engine
303-05 Accessory