Ford Transit 2002 Owner's Manual page 283

While cranking the engine for no more than 30
seconds turn the steering from lock to lock.
With the aid of another technician add 1
liter of clean
17. Wait 60 seconds for the starter motor to cool.
CAUTION: Do not continuously crank the
18.
engine for more than 30 seconds, as damage
to the starter motor may result.
NOTE: When flushing the power steering
system, make sure that the power steering
fluid in the reservoir does not fall below the
minimum mark.
While cranking the engine for no more than 30
seconds turn the steering from lock to lock.
With the aid of another technician add a
further 1 liter of clean
Fluid .
19. When all the fluid has been used, turn the
ignition switch to the OFF position.
20. Lower the vehicle.
21. Remove the blanking cap from the power
steering fluid reservoir and connect the power
steering fluid cooler return line.
22. Attach the power steering fluid reservoir to the
wheelhouse assembly.
23. Attach the coolant expansion tank to the
wheelhouse assembly.
1. Attach the coolant expansion tank.
2. Install the bolt.
Vehicles without common rail fuel injection
24. Connect the fuel injection pump electrical
connector.
http://vnx.su
Power Steering Fluid .
Power Steering