Ford Transit 2002 Owner's Manual page 429

3. CAUTION: The choice of cylinder head
gasket depends on the cast cylinder block
number.
Check the cylinder block number.
4. Position a new cylinder head gasket on the
cylinder block.
Check that the guide bushes are correctly
seated.
5. Install the fabricated locating studs.
6. Install the cylinder head.
Remove the locating studs.
NOTE: Install new cylinder head bolts as
7.
necessary.
Using the special tool, tighten the cylinder head
bolts in the sequence shown in three stages.
Stage 1: 20 Nm.
Stage 2: 40 Nm.
Stage 3: 90 degrees.
8. Install the camshafts.
For additional information, refer to
this section.
NOTE: Install a new exhaust manifold
9.
gasket.
NOTE: Install new spacers to the outer
studs.
Install the exhaust manifold (engine shown
removed for clarity).
10. Install the power steering pump bracket upper
retaining bolts.
http://vnx.su
Camshafts in