Ford Transit 2002 Owner's Manual page 317

2. Install the retaining bolt.
5. Attach the power steering lines to the steering
gear.
6. CAUTION: Make sure the crossmember
ball bearing washers are installed correctly.
NOTE: Install new ball bearing washers.
Using a suitable
and the special tool position and align the
crossmember.
1. Insert the alignment pins through the
crossmember alignment holes and the
washers.
2. Slide the locking plates on top of the
washers and into the groove of the tool
and tighten the alignment pin sleeve.
3. Raise the crossmember engaging the
alignment pins into the chassis aligning
holes.
7. CAUTION: Make sure the crossmember
does not move while tightening the
crossmember retaining bolts.
Install the crossmember assembly (transmission
jack shown removed for clarity).
8. Remove the special tools.
9. Remove the transmission jack.
10. Install the steering gear heat shield.
http://vnx.su
transmission jack , wooden block